- #What cleanflight firmware to use for dodo install#
- #What cleanflight firmware to use for dodo full#
#What cleanflight firmware to use for dodo full#
Swapping any parts or dismantling the drone is out of the question since I'm a newby and do not want to damage any hardware or lose warranty. Nothing I do gives the slightest impression of improvement.
This drifting is total Ebola, is driving me nuts, and after about 10 hours of researching and trying to fix this problem by tweaking pretty much all available settings, I'm close to the point of resignation. The amount of drift increases constantly and starts pretty much right after takeoff.Īny acc trimming via receiver will reset the drifting (not sure if it also resets when landing).Ĭannot say if this problem also persists in acro mode since I'm not yet experienced enough to fly without stabilization. Unfortunately, the drone will drift to the left and back in horizon mode.
#What cleanflight firmware to use for dodo install#
Only had to install the receiver and it was ready to go. I'm totally new to drones and bought a small one last Monday (Sparrow - SkyRc). So, there is no "real" fix for this drift issue? Set gtune_average_cycles = 16 dump rates rateprofile I don't have a spare SciSky board to test with, so I can not rule out a hardware issue.ĭump: version Cleanflight/ALIENWIIF1 1.12.0 / 14:18:34 ( 360fd1a) dump master mixer I think this is a bug that needs looking in to it. Tested the Naze32 and AlienWiiF1 versions.
Tested with CF 1.12, 1.11 and Betaflight 2.3.5. As you see in this video the drift grows over time - the quad is standing COMPLETELY still on the table the whole time. It gets stronger over time until I really have to fight the quad hard not to drift. My micro quad is drifting to the right in ANGLE and HORIZON mode.